run smoothly on 20
amp, 120 volt,
and 60
Hz circuit.
4.2 Connecting the water supply
Connect standard water hose to female fitting on the right side of your QuietCool (looking at the fan blade side). If your
water pressure is above 60 pounds per square inch (p.s.i
).
you must use a pressure regulator (which can be found at your
local hardware store). If you have purchased our optional QR60 gallon reservoir tank – simply attach the garden hose from
the tank to the cooler.
Note:
Do not connect to water source exceeding 60 p
.s.i. –
this can cau
se damage to your QuietCool
.
5.0
Operating procedures
Back your QuietCool unit up to a fresh air source
such as an open door or window so the unit can pull
in fresh air from the outside. Next, make sure you
have a natural exhaust at the opposite end of the
room, bay or building such as a window, door or bay
door
.
This will ensure maximum efficiency from
your unit. Finally make sure there are no obstructions
between your QuietCool and the people / area you
need to cool.
5
.1
Filling the units reservoir with water
Once your
water
hose is connected – open the
water
flow
valve (located on the front of your unit) only
one
and
half (1 1/4) turns.
This
water flow valve adjusts the amount of water to the unit. Next, turn water on and fill the
reservoir with water. Listen carefully. You can hear water filling the reservoir. Check your water connection – make sure
there is no dr
ipping. Once the reservoir is filled with water the float valve will automatically shut off the water source.
When
you no longer hear the water running – you know that the float valve is fully operational (the water turns off automatically)
and you are now
ready to turn on the water pump.
Warning! Do not run water pump without water in the reservoir
.
5
.2
Turn
-
on pump
To turn
-
on the water pump
-
f
lip the toggle switch for the water pump to on. Switch is
located on front side of unit.
Warning! Do not run
water pump without water in the
reservoir
.
The water pump will now begin pumping water to the top of the unit so that
gravity will allow the water to run down the backside of unit
inside and on
the
cooling
pads.
(If the water is dripping off of the pads
on to the floor
–
close the flow valve a
little to slow the water flow. After the pads are wet
–
you can open the valve to 1 ¼ turn.
Allow water to run for 10
–
15 minutes on new
cooling
pads to totally saturate them
with water. Once your units cooling
pads are saturated
–
then, you are ready to turn on
fan and b
egin to feel the cooling effect
from your new QuietCool. Note
:
After your
cooling
pads are broken in (typically
takes 1
-
2 weeks
in operati
on
) it will take less t
ime to saturate pads for
start
-
up.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals